WPS-2900 SERIES

From hss EngineeringOmni-directional Giant Voice® siren system
Output: 109 to 129 dBC at 100’ (30m)
New Page 1
WPS
2900 SERIES
ALERT and INFORM:
The basic purpose
of an all-hazard siren is the ability to ALERT through a tone and INFORM through voice. If
your siren system is producing only a tone, then it’s only doing half it’s job! The most effective way to warn the
public is to issue a siren warning and follow it with a clear, deliberate and powerful
voice message. This two-step approach, ALERT and INFORM, will eliminate confusion, restore
order and most importantly, save lives. Our WPS2900 Series accomplishes this in two ways.
One is to ALERT, the other is to INFORM through omni-directional voice and siren warning.
The WPS2900 Series delivers siren warning and broadcasting of unequalled clarity at
uniform power levels (+/- 1dB) throughout 360°.
SYSTEM FEATURES:
WPS 2900 SERIES includes Ten models, ranging
from 109dBc to 129dBc @ 100’
- All WPS2900
speaker cells include our high efficiency 400 watt EZ-PULL™ speaker drivers
- 50’ cable
included
- Two or three
compartment natural finish aluminum cabinet
- Public address
capability, live voice and pre-recorded messages
- Battery
powered, minimum of 30 minutes of full power output with batteries of our recommendation
- AC temperature
compensated 10 amp battery charger
- Local controls
or remote controls
- Power
amplifiers
- Electronic
siren controller
- Tone
generator
- Timer
- Local control
push buttons
- Battery switch
- Low battery
alarm (two-way only)
SYSTEM OPTIONS:
- SBC280 - Solar
power*
- CTV110 - 12V
110Ah batteriess
- WPSNCMIC -
Noise canceling microphone
- Alternate tone
set
- RDVM - Digital
voice message capability**
NOTES:
*Solar power option
includes 2 - 80 watt panels, mounting bracket and regulator
**RDVM - 1-16
message capability with 240, 480 or 960 seconds available for recording
SIREN ACTIVATION
CONTROLS:
Our
VHF High and UHF siren activation control packages include the following:
- Radio
- Radio
interface
- Tone
squelch
- 2-3dB
Gain omni-directional antenna with bracket
- 15 m
of RG213 antenna cable
- Polyphaser
- SI
TEST®
- Low
battery alarm (two-way only)
Other features are dependent upon one or
two-way controls. Whelen equipment can be interfaced with many different types of two-way
radio communications products and systems including 800Mhz trunking, Motorola’s MOSCAD,
FSK, narrow-band and VHF low band. The following is available as standard options. Contact
factory for special applications.
ONE-WAY CONTROLS:
- AUXIN
- Auxiliary board for contact closure activation
- D2020LL
- 10 digit DTMF landline activation
- D2020H
- 10 digit DTMF VHF high band / 150-170 Mhz
- D2020U - 10 digit
DTMF UHF / 450-470 Mhz
- WPSTT
- Two-tone sequential option
TWO-WAY CONTROLS
- AUXCS
- Two-way contact closure activation and status board
- C2020LL
- Two-way landline activation
- C2020H - 10 digit
DTMF VHF high band / 150-170 Mhz
- C2020U - 10 digit
DTMF UHF / 450-470 Mhz
- C2020NH
- 10 Digit DTMF VHF high band narrow-band
- C2020NU
- 10 digit DTMF UHF narrow-band
OPTIONS:
- FSKXMOD - Converts
the above siren activation controls to FSK format
- STATUS - Cabinet
window LED Status Indicator
- INTRU - Intrusion
alarm (available with two-way only)
- PGINT - Paging
interface to interface Whelen audio, voice and tones with existing paging systems
LIVE PUBLIC ADDRESS
AND PRE-RECORDED MESSAGES:
ALERT and
INFORM! This two-step procedure is accomplished through live public address and
pre-recorded voice messages. Notify YOUR community, base or campus with messages specific
to YOUR needs.
- Live public
address standard
- From 1 to 16
verbal messages and musical renditions of varying lengths may be programmed into all
modules
- Standard
message memory storage is 240, 480 or 960 seconds
- Variable
length messaging standard
SI TEST ®
Only Whelen’s
diagnostic silent test, SI TEST®, fully
exercises the siren system without disturbing the public. Diagnostic SI TEST® information
includes the following:
- AC power
on/off
- DC power at
operational levels
- Partial
speaker driver / power amplifier operation
- Full speaker
driver / power amplifier operation
WPS2900 Series Specifications
| MODEL |
SPL
@ 100’ |
SYSTEM WATTAGE |
HEIGHT
Inches(cm) |
WIDTH
Inches(cm) |
DEPTH
Inches |
SPEAKER
ASSEMBLY
WEIGHT
lbs. |
ELECTRONIC
CABINET
WEIGHT
lbs. |
| VOICE AUDIO |
SIREN AUDIO |
WPS2901 |
109dBc |
400 |
500 |
18.7
(47.5) |
32.5
(82.5) |
- |
107 |
117 |
WPS2902 |
115dBc |
800 |
1000 |
31.1
(79) |
32.5
(82.5) |
- |
156 |
124 |
WPS2903 |
119dBc |
1200 |
1500 |
43.5
(110.5) |
32.5
(82.5) |
- |
205 |
131 |
WPS2904 |
121dBc |
1600 |
2000 |
56.0
(142) |
32.5
(82.5) |
- |
254 |
138 |
WPS2905 |
123dBc |
2000 |
2500 |
68.4
(173.7) |
32.5
(82.5) |
- |
303 |
145 |
WPS2906 |
125dBc |
2400 |
3000 |
80.8
(205) |
32.5
(82.5) |
- |
362 |
192 |
WPS2907 |
126dBc |
2800 |
3500 |
93.2
(237) |
32.5
(82.5) |
- |
411 |
199 |
WPS2908 |
127dBc |
3200 |
4000 |
105.6
(268) |
32.5
(82.5) |
- |
460 |
206 |
WPS2909 |
128dBc |
3600 |
4500 |
118.1
(300) |
32.5
(82.5) |
- |
509 |
213 |
WPS2910 |
129dBc |
4000 |
5000 |
130.5
(331.4) |
32.5
(82.5) |
- |
558 |
220 |
Electronics
Cabinet
(WPS2901 to 5) |
- |
- |
- |
- |
30.0
(76) |
10.0
(25.4) |
- |
- |
Electronics
Cabinet
(WPS2906 to 10) |
- |
- |
- |
- |
30.0
(76) |
10.0
(25.4) |
- |
- |
|  Datasheet (in pdf) Installation manual (in pdf) Operation manual (in pdf) 
|